So I've found myself in the fortunate position of basically being settled on my equipment so I'm trying to sell off the excess parts/horns I have lying around. I've put this YSL646 up before but there are obvious flaws that I'm probably going to have fixed but that = $$$. I'd hate to put money into it if I could work something out with someone that would be a better fit for someone anyway.

Here are a few options:

Bell:

8" or 8.5" bell (8.5" is the stock bell)

Neckpipe:

Straight (No F attachment)

Single F attachment ~.547 rotor/tubing

Single F attachment .530 rotor/tubing

Inline/dependent rotors (two 547 or two 530... or one of each because why not?!) with enough tubing for most tuning configurations. Open/closed wrap.

Three rotors - sure, why not? :pant:

Slide:

Existing 646 slide (single bore 525). Have some parts to make 500/525 or sell with my 356G slide (also 500/525) instead.

New 646/645 crook installed on the existing slide but I have several others as well. King 4B (yellow), Conn 88 (nickel), YSL8820 (Yellow) which would be oversized but could work nicely.

If you were in the market for anything like the above, let me know. Will work on price. No need to have 4 valve sections sitting around the house collecting dust!

Matt are you selling this as one horn put together or one in parts?

[quote="mrdeacon"]Matt are you selling this as one horn put together or one in parts?[/quote]

Either or! I figure its better to see what people are interested in (had a few bites interested in an assortment of combinations) rather than having work done and trying to sell that. As it turns out, I'd have been quite incorrect if I were to have tried to guess what would be the most desired!