Best Cleaner for Slide

TrombaLeese · by **TrombaLeese** » 2023-12-23 2:05 p.m.

Hi -

I'm new to playing trombone and purchased a brand new Xeno It was recommended by the store's tech :) where I bought to use liquid dish detergent in warm water. I've seen Yamaha Brass Soap advertised online and would appreciate feedback as to whether you all prefer one over the other or if it's six of one, half a dozen of the other. Thanks. :)

Burgerbob · by **Burgerbob** » 2023-12-23 2:39 p.m.

Dish soap is fine. Just keep the water warm at most (not hot) and it'll be fine.

tbonesullivan · by **tbonesullivan** » 2023-12-24 3:43 p.m.

Seconded on the normal dish soap. I'm not sure exactly what the Yamaha soap is designed to do that standard dish soap wouldn't deal with.

ghmerrill · by **ghmerrill** » 2023-12-24 4:42 p.m.

I use Simple Green, but otherwise would use (blue) Dove.

brumpone · by **brumpone** » 2023-12-28 6:11 a.m.

What's the UK translation of dish soap, please? Is it just regular washing-up liquid, such as Fairy?

ghmerrill · by **ghmerrill** » 2023-12-28 7:24 a.m.

A web search of "UK dish soap" will give you all the information you need.

ithinknot · by **ithinknot** » 2023-12-28 9:41 a.m.

[quote="brumpone"]What's the UK translation of dish soap, please? Is it just regular washing-up liquid, such as Fairy?[/quote]

yup

Slidehamilton · by **Slidehamilton** » 2023-12-28 10:58 a.m.

As a repair tech, I can tell you that cleaning your slide with lacquer thinner is the way to go. It's a great solvent and won't remove your lacquer. Put it on some cheese cloth, and work it in and out of the slide, keeping it good and tight in there, as to get all the dirt.

ghmerrill · by **ghmerrill** » 2023-12-28 11:18 a.m.

The juxtaposition of "lacquer thinner" and "won't remove your lacquer" is a bit jarring and incompatible with much empirical observation and warnings from a variety of sources. It may depend on what you mean by "lacquer" or what kind of "lacquer" you mean. I wouldn't use it around any of my instrument finishes. Of course, I'm not a repair tech.

tbonesullivan · by **tbonesullivan** » 2023-12-28 3:29 p.m.

Lacquer thinner will 100% strip the Lacquer right off most Bach trombones and other instruments made during the 20th century. I'm not sure when they stopped using Cellulose Lacquer, but it wasn't until relatively recently.

Beaker · by **Beaker** » 2023-12-29 9:29 p.m.

Absolutely do not use lacquer thinner or any flammable solvent for that matter inside your home or an enclosed room near any ignition source!

Posaunus · by **Posaunus** » 2023-12-29 9:41 p.m.

I won't take the risk, but one of the best techs I know carefully cleans and polishes the inside of outer slides with lacquer thinner. And successfully gets away with it. [Perhaps not on Bach slides? :idk: ]

ghmerrill · 2023-12-29 10:43 p.m.

[quote="Posaunus"]... one of the best techs I know carefully cleans and polishes the inside of outer slides with lacquer thinner. ][/quote]

Well, there's the key, and sign of a rational approach -- rather than "Don't worry, it can't harm your lacquer". Still, there are less toxic, less risky, and no less effective alternatives. So why use it? I mean, I have about half a gallon of MEK in my barn, but I almost never use it because there are almost always alternatives that are better practical choices. I also don't use hydrochloric acid to clean my rotary valves, though I might do that as a matter of course if I were in the business of cleaning rotary valves as part of doing chem cleans on customers' instruments -- because under those circumstances there would be additional justifications for doing that.

Edit: corrected reference to hydrochloric acid. :roll:

BGuttman · by **BGuttman** » 2023-12-29 11:04 p.m.

>hydraulic acid

Which one is that? :amazed: :???: :horror: :tongue:

ghmerrill · by **ghmerrill** » 2023-12-29 11:33 p.m.

[quote="BGuttman"]>hydraulic acid

Which one is that? :amazed: :???: :horror: :tongue:[/quote]

:lol: :lol: :lol:

Mea culpa ... (I won't go with the usual excuse here that it was an auto-correcting spell checker that did it.)

Age - related brain malfunction. I spent so much time this past year rebuilding the hydraulic system on my 1974 tractor that that's still embedded in my brain.

I of course meant "hydrochloric" (or "muriatic" for a somewhat different crowd). :roll:

hornbuilder · by **hornbuilder** » 2023-12-30 10:32 a.m.

Just as there are "lacquers", and there are lacquers, there are also "lacquer thinners" and lacquer thinners. They aren't all the same!! I use Cleanstrip Green lacquer thinners to clean the inside of slide tubes after polishing the new tubes. It very effectively removes grease from brass, and flashes off very quickly, with zero residue, but that product is much "milder" than the lacquer thinner I use to actually thin my lacquer made by Niklas! The Niklas baked on epoxy lacquer is completely impervious to the Cleanstrip product. Shires also use the Cleanstrip Green in their slide cleaning routine with all new slides, FWIW.

ghmerrill · by **ghmerrill** » 2023-12-30 11:28 a.m.

Yes. One must be wary of giving vague or easily misinterpreted instructions to the inexperienced. :)

StephenK · by **StephenK** » 2023-12-30 7:25 p.m.

Dish soap= washing up liquid.

Use a 'snake' brush, quite cheap and easily available.

A slide o mix cleaning rod with towelling sheath is very useful. Not so cheap, can be obtained on line eg Dawkes, blue for wide bore, red for medium/ small.

Gameboy64 · by **Gameboy64** » 2024-02-01 8:00 p.m.

For a clean slide, I'd say go for a lukewarm bath with some dish soap, and snake out the insides of the slides, just like the others have said.

However, for a FAST slide, you'll wanna get a cleaning rod with either a cleaning sheath or cheese cloth and use that. I've been doing this for a couple years now and it's never failed me. Burgerbob has a great video tutorial on YouTube about how to do it properly, so I'd check that out.

Posaunus · by **Posaunus** » 2024-02-01 8:52 p.m.

I'm a little wary of "snakes" and their stiff brushes and the potential for damage (or at least some mild scratching) of tubing inner surfaces. I prefer to use the HWP Brass-Saver (soft pull-through brush with a long plastic lead ribbon – will pass through the entire outer slide, including the end crook!). I use the "Tuba" size for large-bore tenor and bass trombones. No chance whatsoever of damage - and you know the slide crook is open and free. I even pull my Brass-Saver though my trombone's bell section (including F-attachment valve).

The Brass-Saver is an integral part of my regular post-playing trombone hygiene protocol. Because I keep them clean, it's only VERY seldom that my trombones need baths.

Mamaposaune · by **Mamaposaune** » 2024-02-02 11:34 a.m.

Benefect Atomic Degreaser works great, and it is safe to use. The downside is that it is sold by the gallon, and costs about $40. A lifetime+ supply for a trombonist, especially since it can be diluted with water and still be effective. However, most will probably find other uses for it.

Posaunus · by **Posaunus** » 2024-02-02 11:43 a.m.

[quote="Mamaposaune"]Benefect Atomic Degreaser works great, and it is safe to use. The downside is that it is sold by the gallon, and costs about $40. A lifetime+ supply for a trombonist, especially since it can be diluted with water and still be effective. However, most will probably find other uses for it.[/quote]

What's the benefit of a "degreaser" on a trombone slide? :idk:

ghmerrill · by **ghmerrill** » 2024-02-02 11:49 a.m.

So you don't oil your valve(s) or oil/grease your slide? Besides, it's an ATOMIC degreaser!!

Also, all that grease from the ribs you're eating while practicing has to go somewhere.

Bonearzt · by **Bonearzt** » 2024-02-03 4:30 p.m.

IMHO, there's NO reason for the average Trombonist to use anything stronger than regular dish soap!!!

The costs involved and associated risks are not worth the possibility of f.. errr mucking up your slide!

A cleaning rod with cheesecloth, flexible snake for the crook and inner tubes are plenty sufficient for typical maintenance. Even just plain water from the hose with the pressure nozzle works wonders!

Anything more than that warrants a trip to a Tech!!

legendary27 · by **legendary27** » 2024-02-11 9:28 a.m.

+1 for warm water and a little washing up liquid, well diluted.

Quick Links

Instruments

Marketplace

Best Cleaner for Slide